Raritan PX-1000 Series Guide de l'utilisateur télécharger pdf (Page 84)

Chapter 5: Using the Web Interface

Access Security Control

Dominion PX provides tools to control access. You can require HTTPS

encryption, enable the internal firewall and create firewall rules, and create

Tip: You can also create and install the certificate or set up external

authentication servers to control any access. See Setting Up an SSL

Certificate (on page 83) and Setting Up LD

AP Authentication (on page

88).

Forcing HTTPS Encryption

HTTPS uses Secure Sockets Layer (SSL) technology to encrypt all traffic

to and from the Dominion PX device so it is a more secure protocol than

HTTP.

You can force users to access the Dominion PX web interface through the

HTTPS protocol only. By default, this protocol is enabled.

To force HTTPS access to the web interface:

1. Choose Device Settings > Security > Force HTTPS for Web Access.

2. A message appears, prompting you to confirm the operation. Click

Yes to enforce the HTTPS service.

3. Choose Device Settings > Security to verify the "Force HTTPS for

Web Access" checkbox is selected as shown in this diagram.

If the checkbox is not selected, repeat these steps.

After enabling the HTTPS protocol, all access attempts using HTTP are

redirected to HTTPS automatically.

Configuring the Firewall

Dominion PX has a firewall that you can configure to prevent specific IP

addresses and ranges of IP addresses from accessing the Dominion PX

device. By default the firewall is disabled.

To configure the firewall:

1. Enable the firewall. See Enabling the Firewall (on page 73).

2. Set the defau

lt policy. See Changing the Default Policy (on page

73).

3. Create fire

wall rules specifying which addresses to accept and which

ones to discard. See Creating Firewall Rules (on page 74).

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 257 258

Pas de commentaire

Raritan PX-1000 Series Guide de l'utilisateur Page 84