Raritan PX-1000 Series Guide de l'utilisateur télécharger pdf (Page 44)

Chapter 4: Using the PDU

 The text “FuP,” which indicates that the Firmware uPgrade is being

performed

 The text "CbE," which indicates the selected circuit breaker has

tripped

LEDs for Measurement Units

Five small LED indicators are adjacent to the three-digit row: four

measurement units LEDs and one Sensor LED.

The measurement units vary according to the readings that appear in the

three-digit row. They are:

 Amp (A) for current

 Volt (V) for voltage

 Kilowatt (kW) for active power

 Unbalanced load (%)

One of the measurement unit LEDs will be lit to indicate the unit for the

value currently shown in the three-digit row.

The Sensor LED is lit only when Dominion PX detects the physical

connection of any environmental sensor.

-- OR --

Two-Digit Row

The two-digit row shows the number of the currently selected line or circuit

breaker. Values that may appear include:

 Cx: This indicates the selected circuit breaker, where x is the circuit

breaker number. For example, C1 represents Circuit Breaker 1.

 n: This indicates the neutral line on a three-phase Y-wired PDU.

 Lx: This indicates the selected line of a single-inlet PDU, where x is

the line number. For example, L2 represents Line 2.

Note: For a single-phase model, L1 current represents the Unit

Current.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 257 258

Pas de commentaire

Raritan PX-1000 Series Guide de l'utilisateur Page 44