Raritan P2-USTIP1 Guide de l'utilisateur télécharger pdf (Page 14)

8 USTIP USER GUIDE

Physical Connections

Figure 5 P2-USTIP2 Rear Panel Connections

Attaching a Local Console for Initial Configuration

1. Attach the included AC power cord to the USTIP unit and plug the other end into a nearby

AC power outlet.

2. Connect the client PC to the USTIP ADMIN Port using a serial (DB9) cable.

3. Connect a standard Ethernet cable from the Network Port to an Ethernet switch, hub, or

router.

4. On a USTIP1 unit, connect the single Paragon port to the User port on your UMT unit using a

CAT5 cable. On a USTIP2 unit, connect both the upper and the lower Paragon ports to User

ports on your UMT unit using CAT5 cables. The upper Paragon port allows you to download

the Paragon database to the USTIP unit, and the lower Paragon port allows local access to the

Paragon unit.

5. Launch a HyperTerminal session from the client PC. To access the Serial Admin Port, use

HyperTerminal to configure specific settings with the following steps:

A. In Windows, click on the Start menu in the lower left corner, then click Programs 

Accessories  Communications  HyperTerminal to start a session.

B. Name the HyperTerminal session, select a session icon - if required - and then click OK.

C. In the Connect To window, click on the Connect Using drop-down arrow and select

COM1 (or other option, depending on where your PC's serial cable is connected) and

click OK.

D. In the COM1 Properties window, click on the Port Settings tab. Make sure the Bits per

second is set to 115200 and Flow control is set to NONE. Click OK.

E. On the File menu, click Properties; click on the Settings tab, then click on the

Emulation drop-down arrow and select VT100.

i. Click ASCII Setup and ensure that the checkbox before Wrap lines that exceed

terminal width is checked.

ii. Click OK.

iii. Click Termi

nal Setup and ensure that the checkbox before Keypad application

mode is checked.

iv. Click OK.

F. Click OK.

6. Power ON USTIP.

Note: HyperTerminal is not available in Windows Vista. For Windows Vista users, you can

download the free terminal emulation software PuTTY from Internet for serial connection.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

Pas de commentaire

Raritan P2-USTIP1 Guide de l'utilisateur Page 14