Raritan P2-USTIP1 Guide de l'utilisateur télécharger pdf (Page 13)

CHAPTER 2: INSTALLATION 7

Note that KVM switch brands other than Raritan’s may or may not properly handle PS/2-to-Sun

signals.

On target servers running the Solaris operating system, set the mouse acceleration value to

exactly 1 and threshold to exactly 1. Set this at the graphical user interface (shown below), or

with the command line “xset mouse a t” where “a” is the acceleration and “t” is the threshold.

Figure 4 Set Mouse Motion

Apple Macintosh Settings

For target servers running an Apple Macintosh operating system, while using USTIP to access

and control your target server, you must set the USTIP client (Raritan Remote Client) to “single

cursor” mode. Dual cursor mode is not supported, and the two mouse pointers will not appear in

sync if you attempt to control a Macintosh server via USTIP in dual cursor mode.

Configuring Network Firewall Settings

If you wish to access USTIP through a network firewall, your firewall must allow communication

on TCP Port 5000. Alternatively, USTIP can be configured to use a different TCP port of your

own designation (see Chapter 3: Administrative Functions, Network Configuration).

In order to take advantage of USTIP's web-access capabilities, the firewall must allow inbound

communication on TCP Port 443 – the standard TCP port for HTTPS communication. In order to

take advantage of USTIP's redirection of HTTP requests to HTTPS (so that users may type the

more common, "http://192.168.0.192", instead of "https://192.168.0.192"), then the firewall must

allow inbound communication on TCP Port 80 – the standard TCP port for HTTP communication.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Pas de commentaire

Raritan P2-USTIP1 Guide de l'utilisateur Page 13