Raritan DOMINION SX - Guide de l'utilisateur télécharger pdf (Page 255)

Appendix A: Specifications

236

Dominion SX Terminal Ports

All Dominion SX models, except the DSX16 and DSX32, have the same

pinouts on the two DB9M serial ports. This applies to models with two

serial ports. All dual-LAN (dual-power) models have one RJ-45 serial

port. The DSX16 and DSX32 models have only one external DB9M

serial port (labeled TERMINAL). All dual-LAN (dual-power) models have

one RJ-45 serial port. The DSX16 and DSX32 models have only one

external DB9M serial port (labeled TERMINAL).

Both ports support a VT100 terminal or equivalent (that is, a PC running

VT100 emulation software such as HyperTerminal

or Linux

Minicom).

Local port access must be enabled and set to the same speed as the

managed device for it to work. Local port access can be enabled or

disabled from the GUI and the CLI using the lpa command through SSH

or Telnet, if it is enabled. The telnet server on the Dominion SX unit is

disabled by default.

Models with two terminal ports support an external modem only on the

port with the RI signal. On models with only one serial port, a modem is

built in. The externally accessible serial port does not include the RI

signal, so it supports only devices such as a VT100 terminal or

equivalent.

The following table identifies the first DB9M serial port pinouts.

DB9M PIN

SIGNAL

DCD

RxD

TxD

DTR

GND

DSR

RTS

CTS

The second DB9M serial port supports only two pins as identified in the

following table (Pin 4 and pin 7 are fixed too high).

DB9M PIN

SIGNAL

RxD

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 310 311

Pas de commentaire

Raritan DOMINION SX - Guide de l'utilisateur Page 255