Raritan P2-USTIP1 Manuel d'utilisateur télécharger pdf (Page 90)

82 PARAGON II USER MANUAL

Rear Mount

1. Secure the cable-support bar to the front end of the side brackets, near the side brackets’ “ears,” using

two of the included screws.

2. Slide the User Station or Base Unit between the side brackets, with its rear panel facing the cable-

support bar, until its front panel is flush with the back edges of the side brackets.

3. Secure the User Station or Base Unit to the side brackets using the remaining included screws (three on

each side).

4. Mount the entire assembly in your rack and secure the side brackets’ ears to the rack’s front rails with

your own screws, bolts, cage nuts, etc.

5. When you attach cables to the connectors on the rear panel of the User Station or Base Unit, drape

them over the cable-support bar.

Figure 66 Rear rackmount of a P2 Base Unit

Figure 67 Rear rackmount of a P2 User Station

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 109 110

Pas de commentaire

Raritan P2-USTIP1 Manuel d'utilisateur Page 90